e-STUDIO350/352/353/450/452/453 © 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND SELF-DIAGNOSTIC MODE
2 - 50
367 RADF RADF original guide width
adjustment (Minimum)
ALL - - Stores the current
width of RADF original
guide by keying in this
code with the guide set
at the minimum width.
Perform this adjust-
ment when the RADF
board or volume is
replaced, or when the
code (05-356) is per-
formed.
6
368 Laser RADF original guide width
adjustment (Maximum)
ALL - - Stores the current
width of RADF original
guide by keying in this
code with the guide set
at the maximum width.
Perform this adjust-
ment when the RADF
board or volume is
replaced, or when the
code (05-356) is per-
formed.
6
401 Laser Fine adjustment of polygo-
nal motor rotation speed
(adjustment of primary
scanning direction repro-
duction ratio)
PRT 133
<0-255>
M When the value
increases by “1”, the
reproduction ratio of
primary scanning direc-
tion increases by
approx. 0.07%.
(approx. 0.1mm/step)
1
405 PPC 129
<0-255>
M
410 Laser Adjustment of primary
scanning laser writing start
position.
PPC 128
<0-255>
M When the value
increases by “1”, the
writing start position
shifts to the front side
by approx. 0.0423mm.
1
411 PRT 128
<0-255>
M
421 Drive Adjustment of secondary
scanning direction repro-
duction ratio (fine adjust-
ment of main motor speed)
PPC/
PRT
138
<0-255>
M When the value
increases by “1”, the
reproduction ratio of
secondary scanning
direction increases by
approx. 0.04%.
1
422 FAX 139
<0-255>
M
424 Drive Fine adjustment of exit
motor speed
PPC/
PRT
107
<0-255>
M When the value
increases by “1”, the
rotation becomes faster
by approx. 0.05%.
1
425 FAX 121
<0-255>
M
430 Image Top margin adjustment
(blank area at the leading
edge of the paper)
PPC 0
<0-255>
M When the value
increases by “1”, the
blank area becomes
wider by approx.
0.0423mm.
1
431 Image Left margin adjustment
(blank area at the left of the
paper along the paper
feeding direction)
PPC 0
<0-255>
M1
Adjustment mode (05) <e-STUDIO350/450>
Code
Classifi-
cation
Items
Func-
tion
Default
<Accept-
able
value>
RAM Contents
Pro-
cedur
e
05/11
To Next Page
Loading...
