1.TROUBLESHOOTING FOR THE HARDWARE
30 Clearing a Paper Misfeed
Misfeed when making copies or prints (using the bypass tray)
1
Clear the paper misfeed following the guidance shown on the touch panel. Then close all the
covers.
2
Press [Yes] when “Cancel print job?” appears.
The print job is canceled.
If you do not want to cancel the print job
To restart the job without canceling it, replace the paper on the bypass tray with that corresponding to the size
set in the equipment after the paper misfeed is cleared. Then if you press [No] in step 2, the job can be restarted.
In this case, it is not necessary to follow step 3 and later.
3
Place the paper on the bypass tray and set the paper size.
4
Try copying or printing again.
To Next Page
Loading...
