2 PRINTING FROM WINDOWS
112 Printing With Best Functions for Your Needs
4
Select two pieces of equipment in the [Selected Devices] boxes and then specify the
number of copies for each one.
y If you select the [Auto] check box, the number of copies set in the [Total Copies] box is automatically and
equally allocated to two pieces of equipment.
y When you select the equipment in the [Selected Devices] boxes, make sure to select that which supports
features enabling all the print options of the job.
- Select equipment which enables stapling if the job needs that.
- Select equipment which enables hole punching if the job needs hole.
- Select equipment with the External Large Capacity Feeder (optional) installed if the job needs it.
- Select color equipment if the job needs full- or twin-color printing.
y If you select the [Always Use This Setting] check box, you can omit the setting of the [Output Devices]
dialog box from the next time.
y Equipment selected in the [Selected Devices] boxes must be registered in [Printer Folder]. If you want to
use equipment not registered in [Printer Folder], add it in [Add Printer] on the [Others] tab of printer driver.
P.65 “Add Printer”
5
Click [OK] to close the [Output Devices] dialog box.
6
Set any other print options you require and click [OK].
7
Click [OK] or [Print] to send the print job.
A job is printed on the selected equipment.
y If the selected equipment does not support features enabling the print options of the job, printing may not be
performed properly.
y Department code confirmation for the selected equipment is not performed when the job is printed from the
selected one. If a department code specified in the [Department Code] box on the [Others] tab is not
recognized on it, Department Management for this print job is not performed.
To Next Page
Loading...
