Toshiba e-STUDIO400P - Department Code; Distinguish Thin Lines; Do Not Print Blank Pages

4 PRINTING FROM UNIX/Linux
168 Printing From Application
 Department Code
The department code can be set using the following option.
A department code is specified within 63 characters.
If the entered department code is longer than 63 characters, it is clipped to 63 characters when a job is sent.
The following characters are invalid for department codes:
" & ' ( ) ; < > ^ ` | ~ @ # % * !
If your equipment is either the e-STUDIO6550C Series or the e-STUDIO4540C Series, enter the department code in a
5-digit number.
y How the equipment performs printing for an invalid department code print job, for which an invalid department code
is specified, varies depending on the Invalid Department Code Print Job setting that can be set in the TopAccess
Administrator mode and whether SNMP communication is enabled or not.
- When SNMP communication is enabled and Invalid Department Code Print Job is set to [Store to invalid job
list], an error message will be displayed when an invalid department code is entered.
- When SNMP communication is disabled and Invalid Department Code Print Job is set to [Store to invalid job
list], the invalid department code print job will be stored in the invalid department code print job list without
printing.
- When the Invalid Department Code Print Job is set to [Print], the invalid department code print job will be
printed.
- When the Invalid Department Code Print Job is set to [Delete], the invalid department code print job will be
deleted.
y For the appropriate department code, ask your system administrator.
 Smoothing
This sets whether to print text and graphics smoothly. This mode can be set using the following option.
Example: The command to set the smoothing mode is “lp -o smoothing=on <filename>”.
 Distinguish Thin Lines
This sets whether to distinguish thin lines or not. This mode can be set using the following option.
Example: The command to set the thin line limit mode is “lp -o thinlinelimit=on <filename>”.
 Do Not Print Blank Pages
This sets whether or not a blank page is printed. This mode can be selected using the following option.
Example: The command to set the blank page mode is “lp -o blankpage=0 <filename>”.
Option Value Alternate Value Description
dept=code Set the department code. A department code within 63
characters comes in [code].
Option Value Alternate Value Description
smoothing=on ON Set the smoothing mode.
smoothing=off OFF Cancel the smoothing mode.
Option Value Alternate Value Description
thinlinelimit=on ON Set the thin line limit mode.
thinlinelimit=off OFF Cancel the thin line limit mode.
Option Value Alternate Value Description
blankpage=0 Set the blank page mode (disable Do not Print Blank
Pages).
blankpage=1 Cancel the blank page mode (enable Do not Print Blank
Pages).