Toshiba e-STUDIO400P - Printer Features

3 PRINTING FROM Macintosh
136 Printing From Application on Mac OS X 10.2.4 to Mac OS X 10.6.x
 Printer Features
In the Printer Features menu, you can set special printing features.
Finishing
In the Finishing menu, you can set the destination, hole punching and stapling.
1) Destination
This selects the destination tray.
- Printer’s Default — Select this to set the output to the default tray (that is set as such for raw jobs in the Printer
setting page of TopAccess Administrator’s page).
- Exit Tray — Select this to set the output to the exit tray of this equipment.
- Upper Exit Tray — Select this to set the output to the upper exit tray of this equipment.
- Side Exit Tray — Select this to set the output to the side exit tray of this equipment.
- Tray 1 — Select this to set the output to the upper tray of the Finisher (optional).
- Tray 2 — Select this to set the output to the lower tray of the Finisher (optional).
y Destinations selectable differ depending on the model and the option configuration.
y Depending on the type of Finisher (optional) installed and destination settings, stapling and hole punching may
not be performed.
y Depending on the equipment settings, the paper may be delivered to a tray that cannot carry out stapling or
hole punching when [Printer’s Default] is selected as the [Destination] option.
y [Tray 1] and [Tray 2] can be selected when the Finisher (optional) or Saddle Stitch Finisher (optional) are
installed.
y [Side Exit Tray] can be selected only when neither of the Finisher (optional) and the Saddle Stitch Finisher
(optional) is installed.
1
2
3
4