Toshiba E-STUDIO5506AC - Replacing Waste Toner Box

Chapter 3 MAINTENANCE
46
1
Open the front cover of the Finisher, pull the
knob to unlock the Finisher, and then
separate the Finisher.
2
Open the waste toner box cover and remove
the waste toner box.
3
Put the lid on the waste toner box.
4
Install a new waste toner box and close the
cover.
5
Close the front cover of the Finisher and
connect the Finisher to the equipment.
Replacing Waste Toner Box
Follow the steps below if a message is displayed on the touch panel informing you that the waste toner box needs
replacing.
The knob of step 1 is inside the cover of the Hole
Punch Unit when it is installed.
Never attempt to incinerate waste toner boxes.
Dispose of used toner cartridges and waste toner
boxes in accordance with local regulations.