Toshiba E-STUDIO5506AC - Specifying E-mail Addresses

Chapter 1 PREPARATIONS
16
Turning OFF
Follow the steps below. Check the following items before turning o the equipment.
•No jobs should be le in the print job list.
•The PRINT DATA lamp (blue) or the MEMORY RX lamp (green) should not be flashing.
(If the equipment is shut down while any of the above lamps are flashing, jobs in progress such as FAX
reception will be aborted.)
•No computer should access the equipment over a network, such as TopAccess.
• When the [ENERGY SAVER] button (green) is on or flashing on the control panel, or the touch panel screen is
still ON, do not press the main power switch to turn the power OFF. Stored data may be lost or the hard disk
may be damaged.
• If you press the [POWER] button while a job is running, a message is displayed asking if you want to delete
the current job and turn o the equipment.
When the equipment is not used for a long period of time:
Select [Shutdown] to select a shutdown option.
Check that the [ENERGY SAVER] button (green) has
stopped flashing and the touch panel screen is o.
Turn the power OFF with the main power switch.
The MAIN POWER lamp (green) turns o.
Press the [POWER] button until you hear a “beep”.
You can then select how to turn the equipment
o. If you press [Hibernate] or [Shutdown], the
screen disappears and the equipment is turned
o aer a short while.
If you press [Hibernate] the memory contents
are saved to the hard disk before turning the
equipment o. Select this if you want to start up
the equipment faster next time it is turned on.
If you press [Shutdown] the system is restarted
and the system’s memory is initialized. Select
this if you will not use the equipment for a long
period.
When turning the equipment back on aer turning it o, wait for approximately 30 seconds.