Toshiba E-STUDIO5506AC - Page 48

Chapter 3 MAINTENANCE
48
1
Open the front cover of the Finisher, and
then pull out the saddle stitch unit.
2
Take out the two empty staple
cartridges.
3
Take the empty staple case out of the
staple cartridge.
4
Install a new staple case into the staple
cartridge and remove the seal bundling
the staples.
5
Install two new staple cartridges.
6
Insert the saddle stitch unit into the
Finisher, and then close the front cover.
Saddle Stitch Unit of Saddle Stitch Finisher