Hook the Accessible Arm over the top of the
Dual Scan Document Feeder to close them.
• Store it near the equipment. When it is stored by putting it on the equipment, choose somewhere where
there is no interference with the paper supply, paper misfeeding release or toner replacement.
• Do not use this for any purposes other than closing the device.
Using the Accessory Tray
•You can use an accessory that weighs up to 3 kg (6.6 lb.) with a width of up to 236 mm (9.29″), a depth
of up to 125 mm (4.92″), and a height of up to 15 mm (0.59″).
•Because the temperature inside the accessory tray can become hot, make sure the accessories placed
on the tray can withstand the following conditions.
Temperature: 10 to 60°C (50 to 140°F); Humidity: 20 to 85%
•Make sure accessories do not fall through the hole in the base of the Accessory Tray.
•Do not force the control panel to move on equipment on which the Accessory Tray is installed.
•Do not trap cables between the equipment’s cover.
•The Extension Tray supplied is 306 mm (12.05″) wide and 150 mm (5.9″) high. When placing
accessories on the Extension Tray, secure them using the attached hook and loop fastener. We
recommend accessories that fit within the size of the Extension Tray.
To Next Page
Loading...
