Toshiba E-STUDIO6508A - Page 37

1.TROUBLESHOOTING FOR THE HARDWARE
Clearing a Paper Misfeed 37
TROUBLESHOOTING FOR THE HARDWARE
2
Separate the Finisher from the equipment.
1. Open the front cover of the finisher when the Hole Punch Unit is not installed. Open the Hole Punch Unit cover
when the Hole Punch Unit is installed.
2. Pull the lever to unlock the finisher.
3. Placing your hands on the positions shown in the figure, move the finisher slowly until it stops, and then open
the front cover of the finisher.
3
Remove the misfed paper from the entrance of the finisher.
When the Hole Punch Unit is not installed When the Hole Punch Unit is installed
When the Hole Punch Unit is not installed When the Hole Punch Unit is installed
When the Hole Punch Unit is not installed When the Hole Punch Unit is installed