Toshiba E-STUDIO6508A - Saddle Stitch Unit

1.TROUBLESHOOTING FOR THE HARDWARE
66 Refilling With Staples
5
Fit the staple cartridge into the stapler.
When fitting the staple cartridge, hold the green-labeled portion of the bracket securely so that the bracket will
not move.
Insert the cartridge until it is caught by the latch and fixed with a click.
6
Close the front cover of the finisher.
If the message “Check staple cartridge” remains, repeat the procedure above from steps 1 to 6.
 Saddle Stitch unit
1
Open the front cover of the finisher, and pull out the Saddle Stitch unit until it stops.
2
Remove the staple cartridges.
Replace both cartridges at a time.
3
Press the buttons on both sides of the cartridge.
The transparent cover of the cartridge is lifted.
2
1
2
1