2. Setting up Network Server
74 Network Administration Guide — Setting up NetWare Print Server
2. Click [Add].
SUPPLEMENT: If the iPrint/NDPS is displayed in the list, iPrint has already been installed during the
installation of NetWare. In that case, you do not have to operate the installation for
iPrint.
3. Insert the NetWare Operating System CD-ROM into your CD-
ROM drive.
4. Select the “PRODUCT.Nl” file that is located in the root of the
CD-ROM, and click [OK].
5. Follow the prompts to install iPrint/NDPS.
Enabling DNS on the Printer Services Manager
Before enabling DNS for the Printer Services Manager, you should add the DNS name
for the Printer Services Manager to the DNS server.
After you add the DNS to the DNS server, follow the steps below to enable the DNS on
the Printer Services Manager.
1. At the server console, enter the following syntax.
NDPSM <NDPS Manager Name> /dnsname=<NDPS Manager DNS Name>
Enabling iPrint Service
After enabling DNS on the Printer Services Manager, enable the iPrint Service using the
iManager.
NOTES: • To do this, iManager must be installed on your NetWare server. For information
about installing iManager, see the documentation for iManager that is provided by
Novell, Inc.
• You must use a supported browser to access iManager. The supported browsers
vary depending on the version of iManager that you installed.
For iManager 1.5.2
- Microsoft Internet Explorer 5.5 or later (Recommended)
- Netscape 6.2 or later
For iManager 2.0.x
- Microsoft Internet Explorer 6 SP1 or later (Recommended)
- Netscape 7.1 or later
- Mozilla 1.4 or later
1. Enter the URL “http://<IP address>:2200” in the address bar
of your browser, and click the iManager link for the NetWare
server under eDirectory iManager.
2. Enter the user name and password to log in to iManager.
3. Click [iPrint Management] in the Contents Panel and click
[Manage Printer].
4. Select the printer that you created for the equipment.
To Next Page
Loading...
