G9 ASD Quick Start Guide 9
Operational and Maintenance
Precautions
• Turn off, lockout, and tag out the main power, the control power, and instrumentation connections
before inspecting or servicing the drive, or opening the door of the enclosure.
• Turn off, lockout, and tag out the main power, the control power, and instrumentation connections
before proceeding to disconnect or connect the power wiring to the equipment.
• The capacitors of the ASD maintain a residual charge for a period of time after turning off the ASD.
The required time for each ASD typeform is indicated with a cabinet label and a Charge LED
(shown for smaller ASDs in Figure 2 on pg. 12; LED is located on the front panel of larger ASDs).
Once the ASD power has been turned off, wait at least the minimum time indicated on the
enclosure-mounted label and ensure that the Charge LED has gone out before opening the door of
the ASD.
• Turn the power on only after attaching (or closing) the front cover and DO NOT remove or open
the front cover of the ASD when the power is on.
• DO NOT attempt to disassemble, modify, or repair the ASD. Call your Toshiba Sales
Representative for repair information.
• DO NOT place any objects inside of the ASD.
• If the ASD should emit smoke, or an unusual odor or sound, turn the power off immediately.
• The heat sink and other components may become extremely hot to the touch. Allow the unit to cool
before coming in contact with these items.
• Remove power from the ASD during extended periods of non-use.
• The system should be inspected periodically for damaged or improperly functioning parts,
cleanliness, and to ensure that the connectors are tightened securely.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
To Next Page
Loading...
