Toshiba G9 ASD - Cable;Terminal;Torque Specifications

G9 ASD Quick Start Guide 75
Cable/Terminal/Torque Specifications
Installation should conform to the 2008 National Electrical Code Article 110 (NEC) (Requirements for Electrical
Installations), all regulations of the Occupational Safety and Health Administration, and any other
applicable national, regional, or industry codes and standards.
Note: The following ratings are guidelines and shall not be the sole determining factor of the
lug or wire size used with the ASD. Application-specific applicables, wire insulation
type, conductor material, and local and regional regulations are but a few of the
considerations when selecting the actual lug and wire type to be used with the ASD.
Note: Cable/Terminal specifications are based on the rated current of the ASD.
The specifications Do Not include the 10% Service Factor.
Note: Use only 75° C copper wire/cable for motor and power connections.
For further installation information see the section titled Installation and Connections on pg. 10.
Note: (*) Indicates that the item is one of a set of two parallel cables.
Table 7. 230-Volt G9 ASD Cable/Terminal/Torque Specifications.
Model
Number
VT130G9U
MCP Rating
(Amps)
Wire/Cable Size
Lug Size Range
Terminal
Board
Torque
AWG or kcmil
Input/Output Power
Wire-Size/Lug-Capacity for
Input/Output Power
TB1 – 4
Terminals
3Ø-
Input
3Ø-
Output
Recommended Maximum 3Ø-Input 3Ø-Output
In-Lbs./Nm
2010
15 14
10 14 to 8
20
(3-core shield)
5.3/0.6
11.5/1.3
2015
2025
2035
30
12
2055 10
2080
50
8 8 12 to 8 17.7/2.0
2110
6
4 10 to 4
21/2.42160 75
38 to 3
2220 100 4
2270 125 2 2 12 to 1/0 4 to 1/0 50/5.7 53/6
2330 150 1
4/0 6 to 250 2 to 300 275/31 168/19
2400 175 1/0
2500 200 3/0
2600 250 4/0
2750 300 *3/0 *4/0
6 to 250 275/31
210K 400 *250 *250
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net