26 G9 ASD Quick Start Guide
Stop-Reset Key — This key has three functions.
1. Issues the Off command (decelerates to Stop at the programmed rate) if pressed once while in the
Local mode in accordance with the setting of F721.
2. Initiates an Emergency Off Fault if pressed twice quickly from the Local or Remote modes. The
Emergency Off function terminates the ASD output and stops the motor in accordance with the set-
ting at F603.
3. Resets active Faults and/or active Alarms if pressed twice quickly. The source of the Fault or Alarm
must be determined and corrected before normal ASD operation can resume.
LED/LCD Screen
The LED Screen is used to display the output frequency, active alarms and/or active faults or Off.
If there are no active alarms or faults, the output frequency is displayed.
During an active alarm, the display toggles to and from the running frequency and the active alarm.
During an active fault, the fault is displayed.
Loss of the ST-to-CC connection flashes Off.
LED Character/Font
Information
Characters displayed on the LED Screen will
be of the seven-segment format. Not all alpha-
numeric characters are used with the LED
Screen.
Listed are the seven-segment characters used
on the LED Screen along with the same
characters as they are displayed on the LCD
Screen.
LCD Font Information
All alpha-numerics are used.
LED/LCD Screen Information
LED
LCD
LED
LCD
A A 1 1
b b 2 2
C C 3 3
d d 4 4
E E 5 5
F F 6 6
G G 7 7
H H 8 8
I I 9 9
J J 0 0
L L
M M
n n
O O
P P
b
q
r r
S S
t t
U U
v v
y y
- -
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
To Next Page
Loading...
