ACE-tronics G9 ASD Installation and Operation Manual 7
System Integration Precautions
The following precautions are provided as general guidelines for the setup of the ACE-tronics G9 ASD
within the system.
• The ACE-tronics G9 ASD is a general-purpose product. It is a system component only and the system
design should take this into consideration. Please contact your ACE World Companies Customer
Support Center for application-specific information or for training support.
• The ACE-tronics G9 ASD is part of a larger system and the safe operation of the ASD will depend
upon observing certain precautions and performing proper system integration.
• Improperly designed or improperly installed system interlocks may render the motor unable to start or
stop on command.
• The failure of external or ancillary components may cause intermittent system operation (i.e., the
system may start the motor without warning).
• A detailed system analysis and job safety analysis should be performed by the systems designer and/
or systems integrator before the installation of the ASD component. Contact your ACE World
Companies Customer Support Center for options availability and for application-specific system
integration information if required.
Personnel Protection
• Installation, operation, and maintenance shall be performed by Qualified Personnel Only.
• A thorough understanding of the ACE-tronics G9 ASD will be required before the installation,
operation, or maintenance of the ASD.
• Rotating machinery and live conductors can be hazardous and shall not come into contact with
personnel. Personnel should be protected from all rotating machinery and electrical hazards at all
times.
• Insulators, machine guards, and electrical safeguards may fail or be defeated by the purposeful or
inadvertent actions of workers. Insulators, machine guards, and electrical safeguards are to be
inspected (and tested where possible) at installation and periodically after installation for potential
hazardous conditions.
• DO NOT allow personnel near rotating machinery. Warning signs to this effect shall be posted at or
near the machinery.
• DO NOT allow personnel near electrical conductors. Contact with electrical conductors can be fatal.
Warning signs to this effect shall be posted at or near the hazard.
• Personal protection equipment shall be provided and used to protect employees from any hazards
inherent to system operation.
efesotomasyon.com -Toshiba inverter,drive,servo,plc
To Next Page
Loading...
