46 ACE-tronics G9 ASD Installation and Operation Manual
Autotune Enable
This parameter is used to enable/disable the
Autotune function.
Autotune 1 = Autotune Disabled or Enabled
Autotune on Run Command.
Speed Control (F986)
2-Step Variable — F, R, and I1.
3-Step Variable — F, R, I3 and I4.
5-Speed — F, R, and Preset Speeds 1 – 4.
2-Speed and 3-Speed — Same as 5-Speed using
only the required number of Preset Speed settings.
Unipolar Analog (RR).
Bi-Polar Analog (RX).
Accel/Decel Times
Accel Time 1 = 10.0 S
Decel Time 1 = 10.0 S
Special Functions
Enable Slow-Speed Limit-Switch — Sets I3 and I4 to Slow-Speed Limit Switch Forward and Slow-
Speed Limit Switch Reverse, respectively.
Enable Stop Limit-Switch for F and R — Sets I5 and I6 to Stop Limit-Switch Forward and Stop
Limit-Switch Reverse, respectively.
Enable Express Speed (F328).
Enable (Plugging F494).
Creep Speed LL (F492) — Sets I4 to Creep Speed 1 Command.
Enable Super Creep — Sets I4 to Super Creep.
Enable Slack Rope Detection (F867).
Speed Reference — Sets I4 to Frequency Reference Priority Switching.
Enable Autotune On Run Command (F400).
Note: Enabling any of the above functions will overwrite the previous function assigned to
the associated discrete input terminal.
efesotomasyon.com -Toshiba inverter,drive,servo,plc
To Next Page
Loading...
