Toshiba G9000 SERIES - Figure 4-2: Wire Connection of Output Bus Bars for MASTER UPS (1000 Kva)

8 G9000 TOSHIBA SYNC KIT 1000-2000kVA Installation Manual - 200151-001
1. Additional wire(Part# 3A) to each output bus bar should be tightened together
with an existing wire on each output bus bar respectively.
2. Additional screws(M4) may not be required.
Figure 4-2: Wire Connection of Output Bus bars for MASTER UPS (1000kVA)
!
NOTE
52SU
52SV
52SW
Color of wires
A-phase: Yellow
B-phase: Blue
C-phase: White
Screw(M4)
Screw(M4)
Screw(M4)
Wires between
Output bus bars(M4)
and fuse holder(M5)
A
B
C
Lower part of bypass cabinet
The connection is for 1000kVA UPS.
To Fuse holder