Toshiba H7 - Page 79

72 H7 ASD Operation Manual
Table 7. Output Terminal Assignment Selections.
Function Function
0 Lower Limit (LL) 30 Forward/Reverse Operation
1 Upper Limit (UL) 31 Ready for Operation (including ST and RUN)
2 Low (speed setting of F100) 32 Ready for Operation
3 RCH (acc/dec completion) 33 POFF Alarm (poor control power supply)
4 RCH (speed specified at F101) 34 System Consistent Sequence (BR: brake release)
5 Fault FL (all) 35 In Alarm Status
6 Fault FL (except EF or OCL) 36 Forward Speed Limit (torque control)
7 Overcurrent Pre-alarm 37 Reverse Speed Limit (torque control)
8 ASD Overload Pre-alarm 38 ASD Healthy Output
9 Motor Pre-alarm 39 Abnormal Communication Alarm 2 (internal cause)
10 Overheat Pre-alarm 40 Error Code Output 1 (6-bit error output)
11 Overvoltage Pre-alarm 41 Error Code Output 2 (6-bit error output)
12 DC Voltage Low Alarm 42 Error Code Output 3 (6-bit error output)
13 Low-current Alarm 43 Error Code Output 4 (6-bit error output)
14 Overtorque Alarm 44 Error Code Output 5 (6-bit error output)
15 Braking Resistor Overload Pre-alarm 45 Error Code Output 6 (6-bit error output)
16 In Emergency Off 46 Designed Data Output 1 (7-bit transmission output)
17 Retrying 47 Designed Data Output 2 (7-bit transmission output)
18 Pattern Operation Switching Out 48 Designed Data Output 3 (7-bit transmission output)
19 PID Deviation Limit 49 Designed Data Output 4 (7-bit transmission output)
20 Start/Stop 50 Designed Data Output 5 (7-bit transmission output)
21
Serious Fault (OCA, OCL, EF, Lost Phase, Short
Circuit, or Abnormal Output)
51 Designed Data Output 6 (7-bit transmission output)
22 Light Fault (OL, OC1, 2, 3, OP) 52 Designed Data Output 7 (7-bit transmission output)
23 Bypass Output #1 53 Light Load Detection Signal
24 Bypass Output #2 54 Heavy Load Detection Signal
25 Fan On/Off 55 Positive Torque Limit
26 Jogging 56 Negative Torque Limit
27 Control Terminal Strip Operation Command Mode 57 External Rush Suppression Relay Output
28 Total-operation-hours Alarm 58 Over Travel
29 Abnormal Communication Alarm (external cause) 59 Positioning Completion
www . ElectricalPartManuals . com