Toshiba HWS-1403XWHM3-E - Page 24

23
Hydro Unit Remote Control
Buttons
1. TEMP. button:
Changes the set temperature for
each operation mode (ZONE1 /
ZONE2 / HOT WATER) by 1°C
step.
10. NIGHT button:
Controls the night set back
operation.
2. SCHEDULE
button:
Sets the current time and
scheduled weekly operation.
11. AUTO TEMP.
button:
Switches setting temperature
automatically according to outside
temperature. (Pressing this button
long changes the mode to data
setting mode).
3. TIME button:
Changes time for current time
setting and scheduled weekly
operation setting with ▼ and ▲
buttons.
12. OPERATE
MODE button:
Selects ZONE1 / ZONE2 operation
mode (heating or cooling).
4. SET button:
Determines the entered current
time setting and scheduled weekly
operation setting.
13. ZONE1, 2
button:
Turns on/off the zone (floor
heating/radiator/FCU) operation.
5. CL button:
Clears settings for the current time
and scheduled weekly operation.
14. ANTI BACTERIA
button:
Regularly increases the hot water
temperature in the tank for
sterilization. (Pressing this button
long changes the mode to data
setting mode).
6. DAY button:
Sets days of the week for current
time setting and scheduled weekly
operation setting.
15. HOT WATER
BOOST button:
Boosts boiling when high tapping
temperature is required temporarily.
7. STEP button:
Specifies switching STEP number
in a day for weekly schedule.
16. HOT WATER
button:
Turns on/off hot water operation.
8. TEST button:
Used for test run or service.
17. SELECT button:
Selects an operation mode when
changing the set temperature of
each operation mode.
9. FROST
PROTECTION
button:
Controls minimum operation for
unused period (going out,
absence,etc.) for anti freezing.
NOTE
Some functions are not provided depending on the system specification in use.