Toshiba XXXXXXX(<SanSerif1>X/X)
–11–
Hydro Unit
Owner’s Manual
• Existing schedule setting
Procedure:
2
→
3
→
4
→
5
→
6
1 Set days of the week.
• Each time the DAY button is pressed, the
mark blinking on the current day of the week at
intervals of 1 Hz shifts sequentially.
• When all days are set at a time, all days (MO to
SU) blink.
• Press the SET button to determine the set
days of the week.
• When the setting is completed, the mark
changes to lighting.
2 Set STEP.
• Select a STEP to be set with the STEP
button, and press the SET button to
determine the selected STEP.
1
→
2
→
3
→
4
→
5
→
6
→
7
→
8
→
C
→
L
→
1
→
….
•1 to 8: Operation program STEP number
•C (Copy):
Set s the operation mode for a day (0:00 to
23:59) simultaneously.
•L (Deletion):
Deletes all the current program operation
settings (for entire week).
3 Set the start time.
• Set the start time with the TIME
buttons.
• When the preset start time is retained, the start
time is displayed.
• If no start time is set, “--’-- --” is displayed.
4 Set temperature.
• Set the temperature for ZONE1 or ZONE2 with
the SELECT button and TEMP.
buttons.
• Press the SELECT button so that
the mark lights for the zone to be changed.
• Enter setting temperature with the TEMP.
buttons.
5 Set operation mode.
• Set the operation mode (heating or cooling) with
the OPERATE MODE button.
6 Determine the settings.
• Press the SET button to determine the
settings.
• The “__” mark lights under the set day of the
week and the “ ” mark appears on the display
for 4 seconds.
• Press the SCHEDULE button to end
the settings.
Copying data
When “C” is selected during the STEP setting, the
setting of the specified day of the week can be copied.
• Press the SET button to determine the copy
mode.
• Specify the day of the week of copy destination with
the DAY button.
• Each time the DAY button is pressed, the
mark on the specified day of the week blinks
sequentially. When all days of the week are blinked,
the data can be copied to all days of the week.
• Press the SET button. When the “ ” mark
appears on the remote controller for 4 seconds, the
setting is completed.
11-EN
+00EF99904001_01EN.book Page 11 Monday, June 28, 2010 6:17 PM
To Next Page
Loading...
