–74–
7. HYDRO UNIT INSTALLATION MANUAL
Engineering Data Book
7
The Hydro Unit can be installed directly without using the fixing angles.
However, the back side of the Hydro Unit can be highly heated, therefore, the installing surface must be heat-
resistant.
Install the Hydro Unit so that its tilting angle falls within the range below.
▼ Fig. 7-05
380
860
M10
M10
Remove the M5a screws to
detach the fixing angles.
Secure the Hydro Unit with
plain washers and nuts.
▼ Fig. 7-06 ▼ Fig. 7-07
± 1°
▼ Fig. 7-08
± 1°
▼ Fig. 7-09
12-EN
To Next Page
Loading...
