What to do if Toshiba MCY-MHP0506HT-E Air Conditioner displays a check code due to duplication of indoor units with priority?
If a check code appears on your Toshiba Air Conditioner's remote controller due to the duplication of indoor units with priority, set up priority for only one indoor unit to resolve the issue.
What to do if Toshiba MCY-MHP0506HT-E Air Conditioner displays a check code due to duplicated outdoor line addresses?
If a check code is displayed on the Toshiba Air Conditioner remote controller due to duplication of outdoor line addresses or a line address setup error after connecting between U1/U2 and U3/U4 connectors, you should modify the line address setup of the outdoor unit between lines by setting up SW13 and SW14 on the interface P.C. board.
Why does my Toshiba MCY-MHP0506HT-E Air Conditioner display a check code when too many indoor units are connected?
If a check code is displayed on the Toshiba Air Conditioner remote controller, it might be because the number or capacity of connected indoor units has been exceeded. Adjust the number or capacity of connected indoor units to resolve this issue.
What to do if Toshiba Air Conditioner displays a check code after address setup?
If a check code appears on the remote controller of your Toshiba Air Conditioner after address setup, and communication from all indoor units is interrupted while a normal operation can be performed, inspect the indoor/outdoor communication line for disconnections. Also, check for any communication noise that might be affecting the system.
What to do if a check code is displayed on the Toshiba MCY-MHP0506HT-E due to transmission circuit trouble?
If a check code is displayed on the Toshiba Air Conditioner remote controller, and it's related to a transmission circuit trouble at the interface side, replace the interface P.C. board.
What to do if a check code is displayed on the Toshiba Air Conditioner due to Indoor / Outdoor communication circuit trouble?
If a check code appears on your Toshiba Air Conditioner's remote controller and you suspect indoor/outdoor communication circuit trouble, check SW30 bit 2 of the outdoor unit. If there is no connection between multiple refrigerant lines, SW30 bit 2 should be on. Also, inspect the communication connector between the indoor and outdoor unit.
What to do if a check code is displayed on the Toshiba MCY-MHP0506HT-E Air Conditioner remote controller?
If a check code appears on your Toshiba Air Conditioner's remote controller, it could be due to several reasons: * The outdoor unit power might be off: Ensure the outdoor unit is powered on. * Address setup errors: Redo the address setup, as there may be undefined or mismatched line addresses, or duplicated indoor addresses. * Communication issues: Check the communication connector between the indoor and outdoor units and verify SW30 bit 2 on the outdoor unit.
What does error code F12 mean on a Toshiba Air Conditioner?
General| Brand | Toshiba |
|---|---|
| Model | MCY-MHP0506HT-E |
| Category | Air Conditioner |
| Language | English |
To Next Page
