SMMS-i
Owner’s Manual
EN
SMMS-i
Owner’s Manual
–10–
5 TIMER OPERATION
Select a timer type from the following three: (Max. 168 hours)
Setting the timer
1 Push the button.
Each time you push the button, the timer mode
and indication change in the following order:
• and the time indicator blink.
2 Push the buttons to set the period of
time until the timer actions.
• The time setting increases in 0.5-hour (30-
minute) increments each time you push .
The setting increases in 1-hour increments if it is
over 1d (24 hours). The maximum is 7d (168
hours).
On the remote controller, settings between 0.5h
and 23.5h (*1) are displayed as is.
If it is over 24 hours (*2), the days and hours
appear.
• The time setting decreases in 0.5-hour (30-
minute) decrements (0.5 hours to 23.5 hours) or
1-hour decrements (24 hours to 168 hours)
each time you push .
Example of remote controller display
3 Push the button.
• disappears, the time indication is
displayed, and or
display flashes.
(When using the ON timer, all indications other
than the time and turn off.)
Cancelling the Timer
1 Push the button.
The timer indicator disappears.
NOTE
• When using Repeat OFF timer, pushing the
button after stopping by the timer starts running
again and the timer will stop the running again after
the specified period.
• When using OFF timer, the timer indication
temporarily disappears for about 5 seconds by
pushing the button. This occurs due to the
processing in the remote controller, and is not a
malfunction.
OFF timer : Stops running after the specified period.
Repeat-OFF timer : Stops running after the specified period every time you use the air conditioner.
On timer : Starts running after the specified period.
1
3
2
• 23.5 hours (*
1
)
Off
Off
On
(Off timer) (On timer)(Repeat Off timer)
No indication (Timer
function is deactivated)
• 34 hours (*
2
)
indicates 1 day
(24 hours).
indicates 10 hours.
(Total: 34 hours)
Days
Hours
SWING/FIX
6 INSTALLATION
Location
• Avoid installing near machines emitting high frequency waves.
• Not suitable for chemical plants such as liquefied carbon dioxide refrigerant plants.
• A failure may occur in certain locations such as the following:
• Areas with large amount of oil droplets (including machine oil) or vapors
• Salty areas near oceans, etc.
• Hot springs emitting sulfidizing gas, etc.
• Heavily acidic or alkaline places.
Special maintenance or parts are required for use in the above places. For details, contact the dealer where you
purchased the product.
• Leave an enough space around the air intake and outlet of the outdoor unit so that the ventilation is not restricted.
• Avoid places where strong wind may blow against the air intake and discharge of the outdoor unit.
• Attach a snow stand, snow hood, etc. to the outdoor unit for use in snowfall areas. For details, contact the dealer
where you purchased the product.
• Make sure drain water from the outdoor unit is emitted into places with good drainage.
• Make sure the air filter is attached to the indoor unit. If not, dust may accumulate on the heat exchanger or other
parts in the air conditioner and cause a water leak.
• Keep a distance of at least 1 m between the air conditioner/remote controller and a TV or radio. Failure to
observe this precaution may cause visual disturbance or noise.
• Leave a distance of at least 1.5 m between the air outlet and a fire alarm. If this precaution is not observed, the
alarm may not work properly or detect fire in case of fire.
Be careful of operation sounds
• Locate the unit in a place secure enough so that the sounds and vibrations do not increase.
• If something is placed near the air discharge of the outdoor unit, noise may increase.
• Be careful not to disturb your neighbors with cool/warm air or noise coming from the air discharge of the outdoor
unit.
19-EN 20-EN
+00EH99936401.book Page 10 Thursday, August 26, 2010 6:52 PM
To Next Page
Loading...
