ELECTRICAL ADJUSTMENTS
D3-4
2-15: OSD HORIZONTAL
1.
2.
Activate the adjustment mode display of Fig. 1-1.
Press the VOL. UP/DOWN button on the remote control
until the difference of A and B becomes minimum.
(Refer to Fig. 2-4)
B
A
TV
00 OSD 15
Fig. 2-4
2-16: SUB SHARPNESS
1.
2.
3.
4.
5.
Activate the adjustment mode display of Fig. 1-1 and
press the channel button (23) on the remote control to
select "SHARP".
Check if the step No. of SHARPNESS is "35".
Press the INPUT SELECT button on the remote control
to set to the AV mode.
2-17: H VCO
Activate the adjustment mode display of Fig. 1-1 and
press the channel button (04) on the remote control to
select "H VCO".
Check if the step No. of H VCO is "04".
1.
2.
Activate the adjustment mode display of Fig. 1-1 and
press the channel button (23) on the remote control to
select "SHARP".
Check if the step No. of SHARPNESS is "30".
To Next Page
Loading...
