3 Tests and Diagnostics 3.31 SETUP
3-106 [CONFIDENTIAL] PORTEGE M400 Maintenance Manual (960-541)
Second HDD →USB → Built-in HDD
: The priority is set as Second HDD → USB → Built-in HDD.
USB → Built-in HDD → Second HDD
: The priority is set as USB → Built-in HDD → Second HDD.
USB → Second HDD → Built-in HDD
: The priority is set as USB → Second HDD → Built-in HDD.
NOTE: If the boot command can not be detected from the prior HDD, booting
target changes to other devices.
Some modules may not be displayed.
7. Others
Whether or not you need to configure the computer with these options depends
primarily on the kind of software or peripherals you use.
(a) Core-Multi Processing
NOTE: This is not displayed in PCs with a single core CPU.
The Core Multi-Processing sets the CPU operating mode.
Enabled Enables Core Multi-Processing functions. (Default)
Disabled Disables Core Multi - Processing functions.
(b) Dynamic CPU Frequency Mode
Use this option to choose a setting from the followings. When the CPU of the
computer is Celeron-M, this option is not displayed.
Dynamically Switchable
Enables Intel
®
Core
TM
Duo Processor or Intel
®
Core
TM
Solo Processor featuring Intel SpeedStep technology.
(Default)
Always High Disables Intel
®
Core
TM
Duo Processor or Intel
®
Core
TM
Solo Processor featuring Intel SpeedStep technology
and always runs the processor at its maximum speed.
Always Low Disables Intel
®
Core
TM
Duo Processor or Intel
®
Core
TM
Solo Processor featuring Intel SpeedStep technology
and always runs the processor at its default speed.
Get user manuals: See SafeManuals.com
To Next Page
Loading...
