Toshiba PORTEGE M400 - Hinge Assembly

4 Replacement Procedures 4.30 Hinge assembly
4.30 Hinge assembly
Removing the Hinge assembly
The following describes the procedure for removing the hinge assembly. (See Figure 4-51
and 4-52.)
1. Remove the following screw and Harness holder.
• M2.5×6.0B FLAT HEAD screw ×1
2. Remove the following screws and LCD harness earth spring.
• M2.5×6.0B FLAT HEAD screw ×1
3. Remove the following screw, antenna cover S and antenna cover T from the slot.
• M2.0×6.0S S-THIN HEAD screw ×1
Harness holder
M2.5×6.0B
FLAT HEAD
M2.5×6.0B
FLAT HEAD
M2.5×6.0B
FLAT HEAD
M2.0×6.0S
S-THIN HEAD
A
ntenna cover S
LCD harness
earth s
p
rin
g
Hinge
assembl
y
A
ntenna cover T
Figure 4-51 Removing the hinge assembly (1)
4-78 [CONFIDENTIAL] PORTEGE M400 Maintenance Manual (960-541)
Get user manuals: See SafeManuals.com