4 Replacement Procedures 4.20 GPU heat sink
4.20 GPU heat sink
Removing the GPU heat sink
The following describes the procedure for removing the GPU heat sink. (See Figure 4-37.)
1. Remove the following screws and GPU heat sink.
• M2.0×3.0S S-THIN HEAD screw ×2
M2.0x3.0S S-THIN HEAD
GPU heat sink
Figure 4-37 Removing the GPU heat sink
Installing the GPU heat sink
The following describes the procedure for installing the GPU heat sink. (See Figure 4-37.)
1. If there is already silicon grease on the GPU and GPU heat sink, clean it with a cloth.
Using a special applicator, apply silicon grease so that the GPU chip on the GPU is
completely covered.
NOTE: For details on applying the silicon grease, refer to Installing the CPU.
2. Install the GPU heat sink and secure it with the following screws.
• M2.0×3.0S S-THIN HEAD screw ×2
4-56 [CONFIDENTIAL] PORTEGE M400 Maintenance Manual (960-541)
Get user manuals: See SafeManuals.com
To Next Page
Loading...
