4.19 MDC 4 Replacement Procedures
4. Turn up two points of insulator and disconnect the MDC cable from the connector
CN4100 on the system board.
MDC cable
CN4100
Insulator
Figure 4-36 Removing the modem cable
Installing the MDC
The following describes the procedure for installing the MDC. (See Figure 4-35 and 4-36.)
1. Connect the MDC cable to the connector CN4100 on the system board and wrap it
with insulator.
2. Connect the MDC cable to the connector on the MDC.
3. Install the MDC to the connector CN3010 on the system board and secure it with the
following screws.
• M2.0×4.0B BIND screw ×2
PORTEGE M400 Maintenance Manual (960-541) [CONFIDENTIAL] 4-55
Get user manuals: See SafeManuals.com
To Next Page
Loading...
