4.30 Hinge assembly 4 Replacement Procedures
4. Peel off four acetate tapes and remove the wireless LAN antennas and Bluetooth
antenna.
5. Remove the following screw and hinge assembly by lifting it up.
• M2.5×6.0B FLAT HEAD screw ×1
cetate tape
cetate tape
Wireless LAN antenna
Bluetooth antenna
Figure 4-52 Removing the hinge assembly (2)
Installing the Hinge assembly
The following describes the procedure for installing the hinge assembly. (See Figure 4-51
and 4-52.)
1. Seat the hinge assembly in place and secure it with the following screw.
• M2.5×6.0B FLAT HEAD screw ×1
2. Stick the wireless LAN antennas and Bluetooth antenna and arrange the wireless
LAN antenna cables and Bluetooth antenna cable in place.
3. Install the antenna cover S and antenna cover T to the slot.
4. Secure the antenna cover S with the following screw.
• M2.0×6.0S S-THIN HEAD screw ×1
5. Install the LCD harness earth spring and secure the hinge assembly and LCD
harness earth spring with the following screws.
• M2.5×6.0B FLAT HEAD screw ×1
6. Install the Harness holder and secure with the following screw.
• M2.5×6.0B FLAT HEAD screw ×1
PORTEGE M400 Maintenance Manual (960-541) [CONFIDENTIAL] 4-79
Get user manuals: See SafeManuals.com
To Next Page
Loading...
