3.31 SETUP 3 Tests and Diagnostics
PORTEGE M400 Maintenance Manual (960-541) [CONFIDENTIAL] 3-109
8. Configuration
This option lets you set the device configuration.
All Devices BIOS sets all devices.
Setup by OS Initializes devices, which is needed to load an operating
system. Operating system initializes other devices.
NOTE: 1. When using installed OS, selecting “Setup by OS” is recommended.
2. When executing test programs, be sure to select “ALL Devices”.
9. Drives I/O
This option displays the address and interrupt level for hard disk drive and optical
disk drive. It is for information only and cannot be changed.
Built-in HDD
This item cannot be changed.
Select Bay This item cannot be changed.
10. PCI Bus
This option displays the interrupt level for the Card Bus in the computer. It is for
information only and cannot be changed.
PCI BUS = IRQ10, IRQ11
11. Security Controller
(a) TPM
Disables the security controller called TPM (Trusted Platform Module).
When the cursor is on the Enable (Disable) and the Space is pressed,
message is displayed and the PC waits Y or N key input by the user.
When Y is pressed, it is sets to Enable (Disable). After changing, the cursor
could not be moved on the TPM tem. This option can be changed after
rebooting.
Disabled Disables the TPM. (Default)
Enabled Enables the TPM.
(b) Clear TPM Owner
This is not displayed when the TPM is set to Disabled. This is executed,
when the PC is disposed or the owner of the PC changes.
When the cursor is on this item and the Space is pressed, message is
displayed and the PC waits Y, E, S and Enter key inputs by the user.
Get user manuals: See SafeManuals.com
To Next Page
Loading...
