4.31 Fluorescent lamp 4 Replacement Procedure
Assembling the cell with PCB
1. Remove the separator from the double-sided tape on the backlight unit.
2. Turn the backlight on.
3. Check that the backlight is free of dust, foreign objects, or damage. Perform this
check also for the reverse side of the cell. Then install the cell with PCB in the
backlight unit.
CAUTION: 1. Align the top left corner of the cell with the corresponding corner of the
backlight unit.
2. Be careful not to damage the TAB.
Figure 4- 60 Replacing 12.1 Inch TMD fluorescent lamp (8)
PORTEGE M400 Maintenance Manual (960-541) [CONFIDENTIAL] 4-89
Get user manuals: See SafeManuals.com
To Next Page
Loading...
