3 Tests and Diagnostics
Subtest 7 Acceleration sensor
This subtest detects and corrects the each axis (X, Y, Z).
NOTE: Make sure that this subtest is executed on the following condition:
1. Flat desk with vertical plane to get the stability of machine.
2. The vertical wall or plane is necessary.
3. Prevent the machine from shake or shock.
3-50 [CONFIDENTIAL] PORTEGE M700/M750 Maintenance Manual (960-661)
Set the machine
against the vertical plane
with the Front upward
<Example>
Vertical plane
Flat desk
The figure below shows the name and position of each side.
Top
(heaven surface)
Right side
Back
Front
Left side
To Next Page
Loading...
