Toshiba Portege M700 - Fan;Heat Sink;Cpu

Fehler! Formatvorlage nicht definiert. Fehler! Formatvorlage nicht definiert.Fehler! Formatvorla
g
e nic
h
PORTÉGÉ M700/M750 Maintenance Manual (960-661) [CONFIDENTIAL] 4-55
4.20 Fan/Heat sink/CPU
Removing the Fan/Heat sink/CPU
The following describes the procedure for removing the fan/heat sink/CPU. (See Figure 4-32
to 4-34.)
1. Remove the following screws, metal plate and CPU hold plate.
• M2.0×4.0B BIND screw ×3
2. Disconnect the fan cable from the connector CN8771 on the system board.
3. Remove the following screws and heat sink.
• M2.0×4.0B BIND screw ×2
4. Remove the fan hood.
5. Peel off the cooling sheet.
CAUTION: Do not reuse the removed cooling sheet.