4.7 Slim select bay module 4 Replacement Procedures
4.7 Slim select bay module
Removing the slim select bay module
The following describes the procedure for removing the slim select bay module. (See Figure
4-10 and 4-11.)
The explanation and figure shown below indicate the optical drive removing/installing.
CAUTION: Do not put fingers in the slim select bay slot. It may cause injury.
1. Remove the following screw securing the latch.
• M2.5×4.0B FLAT HEAD screw ×1
2. Set the removed screw into the screw hole. (The slim select bay is unlocked.)
3. While sliding the latch toward the arrow direction in the Figure 4-10, push the hook
of the slim select bay module and pull out the slim select bay module to disconnect it
from the system board.
Slim select bay module
Latch
M2.5×4.0B FLAT HEAD
Hook
Screw hole
Figure 4-10 Removing the slim select bay module
PORTÉGÉ M700/M750 Maintenance Manual (960-661) [CONFIDENTIAL] 4-21
To Next Page
Loading...
