4.29 Touch pad 4 Replacement Procedures
4.29 Touch pad
Removing the Touch pad
The following describes the procedure for removing the touch pad. (See Figure 4-44 to 4-46.)
1. Peel off the glass tapes.
2. Disconnect the relay cable from the connector on the touch pad.
3. Remove the following screw and touch pad assembly.
• M2.5×4.0B FLAT HEAD screw ×1
M2.5
4.0B FLAT HEAD
Glass tape
Connector
Relay cable
Touch pad assembly
Guide
Glass tape
Figure 4-44 Removing the touch pad (1)
PORTÉGÉ M700/M750 Maintenance Manual (960-661) [CONFIDENTIAL] 4-75
To Next Page
Loading...
