4.20 Fan/Heat sink/CPU 4 Replacement Procedures
6. Set the flat plate under the fan so that stress is not given to the assembly while
disassembling and assembling.
7. Remove the following screws and separate the fan and heat sink.
• M2.5×4.0B FLAT HEAD screw ×2
NOTE: Remove/Install the fan on the flat plate.
M2.5x4.0B FLAT HEAD
Fan
Heat sink
Flat plate
Figure 4-33 Removing the fan
PORTÉGÉ M700/M750 Maintenance Manual (960-661) [CONFIDENTIAL] 4-57
To Next Page
Loading...
