4.23 MDC 4 Replacement Procedures
PORTÉGÉ M700/M750 Maintenance Manual (960-661) [CONFIDENTIAL] 4-67
Installing the MDC
The following describes the procedure for installing the MDC. (See Figure 4-40.)
1. Connect the MDC cable to the connector on the MDC.
2. Connect the MDC to the connector CN3010 on the system board.
3. Arrange the MDC cable in place and wrap it with the insulator.
4. Secure the MDC with the following screws.
• M2.0×4.0B BIND screw ×2
To Next Page
Loading...
