Toshiba Portege R600 - Page 247

4.7 Base assembly 4 Replacement Procedures
4. Remove the following screws securing the base assembly and cover assembly.
• M2×4C S-THIN HEAD screw ×4 (Described as “A” in the figure)
• M2×6C S-THIN HEAD screw ×10 (Described as “B” in the figure)
• M2.5×6C BIND screw ×2 (Described as “C” in the figure)
• M2×2.4C S-THIN HEAD screw ×1 (Described as “D” in the figure)
5. Remove the base assembly while lifting the RJ45 connector side first.
(B)
(B)
(B)
(B)
(B)
(B)
(B)
(C)
(C)
(A)
(A)
(A)
(A)
Cover assembly
(D)
(B)
(B)
(B)
RJ45 connector
Base assembly
Figure 4-8 Removing the base assembly (2)
PORTÉGÉ R600 Maintenance Manual (960-709) [CONFIDENTIAL] 4-19