4 Replacement Procedures 4.7 Base assembly
4-20 [CONFIDENTIAL] PORTÉGÉ R600 Maintenance Manual (960-709)
Installing the Base assembly
To install the base assembly, follow the steps below and refer to Figure 4-7 and Figure 4-8.
1. Set the base assembly to the cover assembly.
2. Secure the base assembly and cover assembly with the following screws.
• M2×4C S-THIN HEAD screw ×4 (Described as “A” in the Figure 4-8)
• M2×6C S-THIN HEAD screw ×10 (Described as “B” in the Figure 4-8)
• M2.5×6C BIND screw ×2 (Described as “C” in the Figure 4-8)
• M2×2.4C S-THIN HEAD screw ×1 (Described as “D” in the Figure 4-8)
3. Connect the ExpressCard FPC to the connector CN2110 on the system board and
insert the tab under the cover.
4. Set the access cover in place and secure it with the screw.
To Next Page
Loading...
