4 Replacement Procedures 4.10 3G card/Wireless LAN card
4.10 3G card/Wireless LAN card
Removing the 3G card/Wireless LAN card
To remove the 3G card/wireless LAN card, follow the steps below and refer to Figure 4-11
and 4-12.
1. Disconnect two 3G antenna cables from the connectors on the 3G card.
2. Remove the following screws and disconnect the 3G card from the connector on the
3G FPC.
• M2×3B S-THIN HEAD screw ×2
3. Disconnect the 3G FPC from the connector CN2750 on the system board.
4. Remove the following screws and 3G FPC.
• M2×4C S-THIN HEAD screw ×2
4-24 [CONFIDENTIAL] PORTÉGÉ R600 Maintenance Manual (960-709)
Figure 4-11 Removing the 3G card
M2×3B S-THIN HEAD
3G card
3G FPC
3G antenna cable (blue)
CN2750
M2×4C S-THIN HEAD
3G antenna cable (red)
To Next Page
Loading...
