124
If Something Goes Wrong
Develop good computing habits
2 Under System and Security, tap/touch Save backup
copies of your files with File History. Follow the
on-screen instructions to back up your files.
For additional Help, launch the Windows Help and Support
screen, and search for “back up files,” see “The Windows
operating system can help you” on page 111.
General tips for installing hardware and
software
Here are a few tips to help ensure safe and easy installation
of new hardware (printers, pointing devices, external hard
drives, scanners, etc.) and software applications like
Microsoft
®
Office and Adobe
®
Photoshop
®
, or utility software
such as special toolbars for your web browser.
❖ Create a restore point (refer to “Saving system
configuration with restore points” on page 121). Before
installing anything, use the System Restore utility to set
a restore point (see the section titled restore points). If
anything goes wrong, you will then be able to easily
restore the Windows operating system to the state it was
in prior to the installation, undoing any changes that the
installation process introduced.
❖ Back up your critical data (see “Backing up your data or
your entire device with the Windows operating system”
on page 123).
❖ Have your back up media on hand in case you need any
files from them.
❖ Do not guess
- follow directions carefully! It is often
necessary to run an installation utility first
- before
connecting a new hardware item to the device. If the
device is connected first, it may be very difficult to
complete the installation successfully. Always carefully
follow the installation instructions that accompany the
hardware or software.
❖ Restart the Windows operating system. Always restart
the Windows operating system after each installation,
even if the installation utility does not prompt you to do
so. This will ensure that the installation is completed,
and will clean up anything that the installation utility left
behind.
To Next Page
Loading...
