User’s Manual C-3
Qosmio F60 Series
*1 Factory-set default channels
*2 The approved channels on using are different at each country or region.
When using these channels in any country or region, refer to the addendum
sheet which is Approved Countries/Regions for use. The channel
configuration is managed as follows:
■ For wireless clients that operate in a Wireless LAN Infrastructure, the
Wireless LAN module will automatically start operation at the channel
identified by the Wireless LAN Access Point. When roaming between
different access points the station can dynamically switch to another
channel if required.
■ For Wireless LAN modules installed in wireless clients that operating in
a peer-to-peer mode, the module will use the default channel 10.
■ In a Wireless LAN Access Point, the Wireless LAN module will use the
factory-set default channel (printed in bold), unless the LAN
Administrator selected a different channel when configuring the
Wireless LAN Access Point device.
5GHz Band Channels Sets
(Wireless IEEE 802.11 Revision a and n)
11 2462
12 2467*
2
13 2472*
2
Frequency Range
Channel ID
5150-5850 MHz
34 5170*
36 5180*
38 5190*
40 5200*
42 5210*
44 5220*
46 5230*
48 5240*
52 5260*
56 5280*
60 5300*
64 5320*
100 5500*
To Next Page
Loading...
Need help?
General
