Toshiba RAS-24GA-ES2 - Page 72

FILE NO. SVM-06021
– 71 –
No. Part name Procedures Remarks
3 7) Remove 7 screws and remove the Drain
pan assembly.
4 <How to remove the Electrical parts assembly>
1) Remove the Air inlet grille, the Front panel
and the Drain pan assembly. (1, 2, 3)
2) Remove the Terminal cover.
3) Unfasten the screw of Cord clamp and
disconnect the connecting cable.
4) Remove the Connector cover and
disconnect the Fan motor cords.
5) Remove the TC sensor and earth wire from
Refrigeration assembly.
6) Remove the Electrical parts assembly.
NOTE : When install the electrical parts
assembly, fix the screw after the Back body
is fixed.
5 <How to remove the Refrigeration assembly>
1) Remove the Air inlet grille, the Front panel
and the Drain pan assembly. (1, 2, 3)
2) Stop the gas at the Outdoor unit.
3) Remove 2 pipes from the Refrigeration
assembly.
4) Remove the TC sensor from holder.
5) Remove the pipe holder.
6) Remove the earth wire.
Drain pan
assembly
Electrical parts
assembly
Refrigeration
assembly
Screw
Drain Pan
Screw
(Continue)
Connecting
cable
Cord clamp
TC sensor
Earth wire
Refrigeration
assembly
Electrical parts
assembly
Fan motor cords
Earth wire
TC sensor
Pipe holder