Toshiba RAS-M18GACV-E - Page 105

– 105 –
Set screw
Screw
Screw
sing
Secure using
screw
the fixing screw
using
Secure using
g screw
the fixing screw
nd (Right)
Motor band (Right)
F
a
n motor l
eads
Raise the
left side
Pull out here
No.
7
8
Part name
Fan
motor
Cross
flow fan
Procedures
1) Follow to the procedure in the item
3
.
2) Loosen the set screw of the cross flow fan.
3) Remove two fixing screws of the motor band
(Right), and then remove the motor band (Right).
4) Pull the fan motor outward.
In assembling work, install the fan motor as follows.
• When assembling the fan motor, the fan motor
must be installed in such a way that the fan
motor leads will be taken out is positioned at
the bottom front.
• After assembling the two hooking claws of the
motor band (right) into the main body, position
the fan motor, insert it, and then secure the
motor band (right) using the two fixing screws.
1) Follow to the procedure in the item
6
.
2) Remove the heat exchanger fixing holder by
removing the two fixing screws used to secure it.
3) Loosen the set screw of the cross flow fan.
4) Lift the left side of the heat exchanger, and pull
out the cross flow fan.
Remarks