– 71 –
1. To know the indoor unit addresses though position of the indoor unit body is recognized
• In case of individual operation (Wired remote controller : indoor unit = 1 : 1)
(Follow to the procedure during operation)
<Procedure>
1
2
2. To know the position of indoor unit body by address
• To confirm the unit No. in the group control
(Follow to the procedure during operation) (in this procedure, the indoor units in group control stop.)
<Procedure>
The indoor unit numbers in the group control are
successively displayed, and fan, louver, and drain
pump of the corresponding indoor unit are turned on.
(Follow to the procedure during operation)
1
2
3
9-4. Confirmation of Indoor Unit No. Position
When the indoor unit is stopped, push [MENU] and [▼]
buttons simultaneously for at least 10 seconds.
• After entering, the screen displays and the indoor unit
number. The indoor unit number displayed first is the main indoor
unit number.
• In the non-group control mode (only one indoor unit), only 1-1 is
displayed on the left.
The displayed 1-1 indicates the address of the piping system and
the address of the indoor unit.
• If other indoor units are connected to the same remote controller
(group control), when [▼] or [▲] button is pushed, the addresses
of other indoor units will be displayed in order.
Push [ON/OFF] button to exit after checking.
Push [MENU] and [▼] buttons simultaneously for at least
10 seconds.
• In the air-conditioning group control mode, and the indoor
unit No. are displayed. The indoor unit number displayed first is
the main indoor unit number.
• In the non-group control mode (only one indoor unit), only 1-1 is
displayed on the left.
The displayed 1-1 indicates the address of the piping system and
the address of the indoor unit.
Push [▼] or [▲] button to adjust the indoor unit address.
The indoor unit number in the group control will be
changed cyclically. Select the indoor unit number to be
identified, and push [TIME] button to confirm. The fan of the
selected indoor unit starts its operation and the swing
operation of the louvers starts after confirmation to
determine the position of the indoor unit.
Push [ON/OFF] button to return to the normal mode after
confirmation.
When [ON/OFF] button is pushed, flashes, then the display
disappears and the air conditioner enters the normal stop mode.
(When flashes, it cannot receive operation instructions from
the remote controller.)
[MENU] [TIME] [▼] [▲] [ON/OFF]
[MENU] [TIME] [▼] [▲] [ON/OFF]
To Next Page
Loading...
