2. Attachment
1) Insert the claws on the left side of the terminal
cover into their slits.
2) Moving the terminal cover downward, insert
the cover in the gap between the terminal box
and screw that you loosened in step 1-1) of
“CTerminal cover” and tighten the screw to fix
the cover in place.
Slit
C
Terminal cover
– 73 –
No. Part name Procedure Remarks
D Electric parts box
cover
1. Detachment
1) Perform step 1 of “CTerminal cover” as
required.
(You may be able to perform this procedure
without removing the electric parts box cover.)
2) Slightly loosen the screw holding the electric
parts box cover in place.
(Ø4×10 2 pcs)
3) Lifting the electric parts box cover upward, pull
the left side of the cover toward you to open it.
NOTE)
If it is difficult to open the electric parts box cover
because of the power supply and communication
cables connected to the cover, disconnect these
cables and perform the procedure.
4) Disconnect the following connectors from the
control P.C. board.
NOTE)
Unlock the lock of the housing to disconnect the
connectors.
CN41 … Remote control connector (2P: Blue)
CN67 … Power supply connector (5P: Black)
5) Lift the electric parts box cover upward and pull
the cover to the left toward you to detach it
from the claws on the right side.
2. Attachment
1) Insert the hooking plates of the main body into
the hook holes on the right side of the electric
parts box cover.
2) Reconnect the cables that you disco
nnected in
step 1-4) of “DElectric parts box cover.”
3) Moving the electric parts box cover downward,
close the electric parts box cover. Insert the
cover in the gap between the box and screws
that you loosened in step 1-2) of “DElectric
parts box cover” and use the screws to fix the
cover into place.
Electric parts box cover
Screws
Hooking part
Control
P.C. board
To Next Page
Loading...
