No. Part name Procedure Remarks
J Under panel,
Drain pan
1. Detachment
1) Tack off the drain cap and drain the drain
water accumulated in the drain pan.
In case off natural drain model,drain the drain
water by taking off hose band and drain hose.
NOTE)
When taking off drain cap and drain hose,be
sure receive drian water in a bucket,ect.
2) Slightly loosen the screw holding the under panel
in place and on both sides of outlet.
(Ø4x10 3pcs; Ø5x10 2pcs)
3) Slowly remove the under panel
4) Pull out the drain pan
NOTE)
• When pulling out the drain pan.never pull out
the drain socket by drawing it with hands.If
doing so,water leak may be caused.
• When pulling out the drain pan, some drain
water may still be left in the pan so be
absolutely sure to discard this water
5) After pulling out the drain pan slightly,to detach
the pan.
2. Attachment
1) Align the drain panplate to the base of the
drainage socket and push it into it.
2) Hook the under panel on the screws that
you untightened in step 1-2)of “
JUnder
panel,Drian pan”and tighten these screws.
3) Attach the drain cap and darin hose that you
removed in step1-1)of”
JUnder panel ,Drain
pan.”When you attach the drain cap and drain
hose,be sure to insert them firmly into the
base of the drain socket of the drain pan.
NOTE)
Finally, be sure to check there is no water
leakage from leakage from each attached
part.
Screws (Ø5x10)
Screws (Ø4x10)
Drain cap and
drain hose
Under panel
Drain pan
– 79 –
To Next Page
Loading...
