Programming
the
remote
control
to
control
your
other
devices
Your Toshiba TV remote control is preprogrammed to operate
most Toshiba devices. To program your TV remote control to
operate a non-Toshiba device (or aToshiba device that it
is
not
preprogrammed to operate), follow the steps below. Fordetails
on using the remote control
to
operate the device, see page 22.
1 In the remote control code table
(~
page 25), find the
code for your device.
If
more than one code is listed, try
each one separately until you find one that works.
2 Set the MODE SELECT switch to the type
of
device
you are programming the remote control to operate -
CABLE/SAT (for a cable converter box or satellite
receiver), AUX I (for a VCR or
TVNCR
combo), or
AUX 2 (for a DVD player or HTIB [home theater in a
box]).
3 While holding down
RE~LL,
press the Channel Number
buttons to enter the 3-digit code for your device.
4 To test the code, tum on the device, point the remote
control
at
it, and press
PO~ER.
See notes below.
•
If
the correct code was entered, the device will tum off.
•
If
the device does not respond, repeat steps
1-4
using
another code.
•
If
the device does not respond to another code, you will
need to use the remote control that came with the
device.
S Remember to set the MODE SELECT switch back to
'TV"
to control the TV.
6 For future reference, write down the code(s) you used:
Note:
•
In
addition
to
POWER,
confirm that allnecessary keys on the
TV
remote control operate your device. Ifsome keys are not
operational, repeat the device code setup using another
code (ifothercodes are listed for your device).
If,
after trying
all listed codes, the necessary keys do not operate your
device, use the device's original remote control.
• Every time you change the batteries, you will need to
reprogram the remote control.
• Some newer
VCRs
respond to either
of
two codes. These
VCRs
have a switch labeled "VCR1NCR2." Ifyour
VCR
has
this kind
of
switch
and
does not respond
to
the codes for
your
VCR
brand, set the switch
to
the other position ("VCR 1"
or "VCR2")
and
reprogram the remote control.
I
24
To Next Page
Loading...
Need help?
General