Viewing
the
digital
signal
meter
You can view the digital signal meter
in
the ANT/CABLE
digital TV input source only.
To view the digital signal meter:
1 From the Setup menu, highlight Installation and press
@.
A new set
of
Installation menu icons will appear.
2 Open the Terrestrial menu, highlight Signal Meter,
and
press@.
3 Press
....
T
....
~
to select the antenna input and digital
channel whose signal you want to check.
Note:
•
The
physical digital channel numberlisted
in
the Signal
Meter screen may not correspond
to
a virtual
TV
channel number. Contact your local broadcasters
to
obtain the RF channel numbers for your local digital
stations.
•
The
signal strength does
not
change between virtual
channels on the same physical channel.
To close the screen and return to the Terrestrial
menu:
Highlight Done and press
@.
To return to normal viewing:
Press
E~!r
Setting
the
time
zone
The Time Zone setup will allow you
to
specify the correct time
zone for your region. This feature will allow the TV status
information to show the correct time zone information
(1&
page 54).
To set the time zone:
1 From the Setup menu, highlight Installation and press
@.
A new set
of
Installation menu icons will appear.
2 Open the Time Zone menu, highlight Time Zone
Setup, and
press@.
3 Press
....
or
~
to
select the region, highlight Done, and
then press
@.
After the time zone has been set, you will be asked to set the
current Daylight Saving Time status.
To set the Daylight Saving Time status:
1 Press
....
or
~
to
select Yes or No, highlight Done, and
then press
@.
33
I
To Next Page
Loading...
Need help?
General